win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: Ball going Looong  (Read 760 times)

Badger856

  • Hero Member
  • *****
  • Posts: 562
Ball going Looong
« on: August 28, 2003, 08:55:20 PM »
I have a Action Carbide drilled with pin at 12:00 a tad over ring finger with MB and inch right of thumb. This ball goes longer than I wanted for house shot. What would a weight hold drilled past my PAP do or is there anything I can do without sanding it down.
Logged

 

charlest

  • Hero Member
  • *****
  • Posts: 24526
Re: Ball going Looong
« Reply #1 on: August 29, 2003, 12:14:56 PM »
Changing the ball's surface is a better and usually more appropriate solution than a weight hole, UNDER NORMAL CIRCUMSTANCES. Ask AZO what the stock finish is on the ball and sand it or nylon pad it with the next lower grit. If you don't like the results, you can always re-sand/re-nylong-pad it back to the original level. Once you drill a hole, you may affect the core, plus refilling the holel rarely seems to restore the ball to what it was previously.
You do realize that drilling the ball with the pin above the ring finger added length to the ball's "natural" reaction, right?
--------------------
"Those who do not remember history are doomed to repeat it."
Logged
"None are so blind as those who will not see."
Pages: [1]
« previous next »