Author Topic: Clean and Dull Help.... (Read 1378 times)

Cyril The Syrup · « **on:** December 20, 2011, 06:20:58 PM »

I just bought my first ever bottle of Clean n Dull but unfortunatley the directions on the bottle are illegible.

Could someone be kind enough to give me a run down on the correct procedure for using it?

Thanks in advance.

tywithay · « **Reply #1 on:** December 21, 2011, 03:39:42 AM »

Depends whether you're using a spinner or not. If you're cleaning a ball by hand I just wipe it on with a paper towel, using a swirling motion around one half of the ball. Let it sit on the ball for 20-30 seconds, then wipe it off with a microfiber towel dampened with ball cleaner. Then I wipe off the ball cleaner with a dry microfiber towel.

I don't know if this is the right way to do it, but it leaves my ball super tacky. I was able to actually palm my pink panther after cleaning it this way one day.

charlest · « **Reply #2 on:** December 21, 2011, 09:19:36 AM »

The original instructions on the Track Clean and Dull bottle indicate the use of water for clean-up.I follow those. Otherwise,it is very similar to what tywithay suggested.

I use a rubber glove, as i feel this is a strong chemical.

I put some on the ball, rub it in in circles over the top half of the ball sitting on the ball cup of the spinner.

(You really don't need a lot, as it comes inthe form of a gel which sit on the ball nicely. Maybe 2 qurter sized dollops is almost too much for each half.)

I keep on wiping it on, keeping the surface wet with C&D, for about a minute.

Then I wipe it off with a wet paper towel. Then I wipe off the water with a dry paper towel.

Repeat on the bottom half, after turning the ball over 180 degrees.

"None are so blind as those who will not see."

BowlingChat.net

scotts33 · « **Reply #3 on:** December 21, 2011, 09:45:08 AM »

Just an FYI on the original Track C&D bottle the HMIS label is 2-health, 0-flammability, 0-reactivity and B-personal protection. 2 on health = Temporary or minor injury may occur. B on personal protection means use safety glasses and gloves. So, as Jeff states use caution when using this product I have no issue using it with proper information.

Scott

jls · « **Reply #4 on:** December 21, 2011, 12:00:17 PM »

tywithay wrote on 12/21/2011 4:39 AM:Depends whether you're using a spinner or not. If you're cleaning a ball by hand I just wipe it on with a paper towel, using a swirling motion around one half of the ball. Let it sit on the ball for 20-30 seconds, then wipe it off with a microfiber towel dampened with ball cleaner. Then I wipe off the ball cleaner with a dry microfiber towel.

Very important to do this...

I don't know if this is the right way to do it, but it leaves my ball super tacky. I was able to actually palm my pink panther after cleaning it this way one day.

jls

Cyril The Syrup · « **Reply #5 on:** December 22, 2011, 01:28:17 PM »

Thanks guys...all very helpfull.

cheech · « **Reply #6 on:** December 22, 2011, 01:37:14 PM »

i use it on a spinner but i use the same steps when i do it by hand. basically just like any other cleaner apply desired amount to hte ball and rub it in so i doesnt splatter everywhere. turn on the spinner and apply pressure until most of the cleaner is gone then take a paper towel or dry towel and rub off the excess

sacred heart university bowling, jr.
greatest accomplishment:shooting 603 and not shooting one 200 game(130,173,300)...lol
balls for sale in my profile
everyone is born right handed, only the gifted overcome it

Author Topic: Clean and Dull Help.... (Read 1378 times)

Cyril The Syrup

Clean and Dull Help....

tywithay

Re: Clean and Dull Help....

charlest

Re: Clean and Dull Help....

scotts33

Re: Clean and Dull Help....

jls

Re: Clean and Dull Help....

Cyril The Syrup

Re: Clean and Dull Help....

cheech

Re: Clean and Dull Help....