I threw an IQ Tour at a demo and it rolled early with an extremely smooth, continuous backend. I basically copied that layout on the one I drilled and it rolls a little too late and is a bit over/under on the backend on fresh patterns, which is what I want it for. I've tried taking the surface down to 800 grit and while it smoothed out in the back a little, it still goes a bit too long. The ball obviously doesn't flare much to begin with so I'm thinking a weight hole could get the ball to roll up a little sooner without making it more angular off the dry. The CG is about a half inch right of the center of grip, and the ball had 1.88oz top weight to start. Where should the weight hole go to give me the reaction I want and keep it statically legal? I've tried reading up and learning but it's too much information to process hours before going to the alley haha. Thanks for the help
