Author Topic: Question (Read 506 times)

Strokewiththelefthand · « **on:** March 28, 2005, 02:53:40 AM »

I got a Roto-grip Oracle Vision (Just to try out, not betraying the nation or anything) and I asked for a 3" pin. Instead, I got a 2" inch pin. I just want to know would I still be able to use a 5x3 drilling or will I just have to drill it another way.
--------------------
But the LORD is the true God, he is the living God, and an everlasting king: at his wrath the earth shall tremble, and the nations shall not be able to abide his indignation. Jeremiah 10:10

JohnP · « **Reply #1 on:** March 28, 2005, 09:47:57 PM »

You can lay it out 5 x 3, but the cg will end up in a straight line from your pin to your PAP, 2" from the pin. Depending on your PAP location and where you want the pin in relation to the midline, you could have to use a fairly large balance hole. -- JohnP

Ragnar · « **Reply #2 on:** March 29, 2005, 08:23:28 AM »

quote:
You can lay it out 5 x 3, but the cg will end up in a straight line from your pin to your PAP, 2" from the pin. Depending on your PAP location and where you want the pin in relation to the midline, you could have to use a fairly large balance hole. -- JohnP

On the other hand, this sort of straight line layout is one of my favorites. Normally I end up with a large, though usually not too deep, balance hole. I like to put the pin up beside or above the fingers with this sort of in-line layout, then a balance hole on the PAP, or just slightly past, still in line.
--------------------
"To plunder, to slaughter, to steal, these things they misname empire; and where they make a wilderness, they call it peace." (Tacitus)
"If one tells the truth, one is sure sooner or later to be found out. " (Wilde)

Author Topic: Question (Read 506 times)

Strokewiththelefthand

Question

JohnP

Re: Question

Ragnar

Re: Question