BallReviews
General Category => Miscellaneous => Topic started by: Raven829 on May 12, 2008, 06:54:54 AM
-
I was wondering if anyone has found a shaft that can attach to either a drill or Dremel-like multitool that can mimic a bevel sander? The mandrels for Dremels are far too short to get down into the holes.
Don
--------------------
"You cannot change the stripes of a leopard."
~Emmitt Smith
-
You can remove the screw from the end of the little drum sander you get with your dremel tool. Replace screw with a piece of bevel sandpaper on the end of the little sanding drum. It works really well. The length of the sander attachemnt plus the mandrel gets to the bottom (or at least deep enough) of the hole. Also you can find a cutting disk tool for the dremel. Replace the cutting wheel with your bevel sandpaper. That work ok to.
-
I don't know if Kingcranker (Paco) still makes them, but he at one time sold a bevel sander that fit into a Dremel tool. Send him a message and see if he still sells them.
--------------------
Penn State Proud
Special thanks to Lane#1 for donations to two consecutive Ballreviews Get Togethers.
Ron Clifton's Bowling Tip Archive (http://"http://www.bowl4fun.com/ron/roncarchive.htm")