I did some measuring tonight, and found that my pap is 4 inches over and 1/2 inch up, but when I measured the track to see how much tilt distance was 11.5-12.0 inches, anyone have any thoughts if this seems logical, I do track the ball fairly low compared to finger and thumb holes. I'm not sure about rev rate probably about 350.

I thought I did but it was hard to see oil track on back side of ball, tried 2 different balls. I'm guessing that the axis tilt is probably not accurate.

I thought I did but it was hard to see oil track on back side of ball, tried 2 different balls. I'm guessing that the axis tilt is probably not accurate.

It could be.
While, for the vast majority of bowlers, a lower track will correspond to a higher numerical axis tilt, it is not 100% correlation. Several PBA professionals have low tracks but also have low axis tilts. So it is possible that while your track, 4" over, is low, your first diameter oil tack could be accurate at 11.5 - 12" (10-13 degrees axis tilt).

Quote from: ignitebowling on November 03, 2018, 09:39:31 PM

I prefer this option for axis tilt and rotation


https://youtu.be/I-btz1SpFtw

This only seems to show axis rotation, not tilt. They tell you to buy other software to find the tilt.

Has both. Just need to do a photo overlay with with your phone or desktop. I use my phone at the bowling center.  Takes only a few minutes.

http://wiki.bowlingchat.net/wiki/index.php?title=File:Rotation-tilt-overlay.jpg