I have a almost new IQ Tour Fusion that was drilled for me no less than month ago. The pin was not tampered with and is no where near my fingers. Upon practicing last night I noticed a medium sized indent when my ball came out of the ball return. Nothing to go complain to management about. Just simply another mark.

Arrived home that night, cleaned it up with a little Tac Up and put it back in the bag. This morning when I got home for lunch, there was a crack from the indent that was made to my thumb hole. I'm still in disbelief right now SMH... My wife bought this ball for me back when we were dating so it really has special value. I made sure to take good care of it prior to it getting drilled. Kept in storage at a neutral temp so it was not neglected.

What if anything can I do to fix this? Or do I just need to accept reality and start looking for a replacement. Thanks in advance 

Stop spamming the forum. You're probably SOL

Probably done

Tough luck. 

Did your warranty run out?

Take it back to where you bought it or had it drilled and see what the shop operator can do for you.  Sometimes the rules can be bent if the ball rep is approached properly.  --  JohnP

Take it back to where you bought it or had it drilled and see what the shop operator can do for you.  Sometimes the rules can be bent if the ball rep is approached properly.  --  JohnP

Will definitely give it a shot. Thanks John

I believe it's once you purchase it.