IMHO:
Fall back shot.
Depending on the oil amount and friction available - it determines the strength of the ball needed.
Pin above the bridge area 5"-5.5"-6" pin to PAP, CG/MB kicked out to reduce the backend to small flip, playing 12-15 board (again, depending on the pattern and your "hand" and ball speed) as the breakpoint.
Normally need a mild to medium-strong pearl or medium-weak solid resin with some to a lot of shine (again depending on the pattern and your hand)!
Your hand and ball speed will give you some area inside and outside. If you have none, you need to adjust rev rate and ball speed and possibly tilt and rotation.
If there's a true out of bounds outside of 10 board, you can use very strong, very early rolling oiler, but drilled for minimal backend. Release control and ball speed control are the premium factors required.
--------------------
"None are so blind as those who will not see."
Edited on 3/9/2009 6:40 PM