BallReviews

Equipment Boards => MoRich => Topic started by: scotts33 on September 28, 2008, 03:05:53 AM

Title: Drilling a SolidLevRg
Post by: scotts33 on September 28, 2008, 03:05:53 AM

I'm drilling a SolidLevRg later in the week.  Drilling request came back with this info.

I gave them my stats and this is what they came up with.
Drilling Angle = 55 Degrees
Pin to PAP distance = 4 1/2"
Angle to the VAL = 50 Degrees

Going to use this ball as a bench mark or try to anyway.  I have not drilled any MoRich balls since an OnSlaught.  Which was used.

Being that they are drill specific to given lane condition.  Do folks think forward roll is necessarily better than side roll on any given layout and lane condition?  Maybe just consistent release is the best?

Thanks for your opinions.





--------------------
Scott

Title: Re: Drilling a SolidLevRg
Post by: scotts33 on September 29, 2008, 06:30:03 AM

Seems like not many respond anymore in the MoRich section.  Nobody using them?  

To bad kotm and JeffRevs don't use this forum anymore.  
--------------------
Scott