BallReviews

Equipment Boards => MoRich => Topic started by: stormerjip on October 19, 2005, 04:01:41 PM

Title: drilling question
Post by: stormerjip on October 19, 2005, 04:01:41 PM

could u put a pin under ring with mb right of thumb on a mayhem and what kind of reaction could i expect out of it
--------------------
show no mercy, kill the wounded, eat the dead

Title: Re: drilling question
Post by: DrillLord on October 20, 2005, 02:51:09 PM

All depends on where your track is.  For me, pin under ring is a very mild drilling since my track is so high.  A friend of mine has a low-track spinner release and pin under finger is a max leverage position.  How far righ of the thumb are you talking?  between the thumb and VAL?? on the VAL??  Really need more information before an accurate estimate could be found.
--------------------
I've found that the RESET button is the easiest way to knock down ten pins.

Title: Re: drilling question
Post by: stormerjip on October 20, 2005, 04:43:12 PM

just rightof thumb
 this is by far my fav drilling but i know some people have said that morich balls can be really drilling specific  and didn't know if this was feasible or not
--------------------
show no mercy, kill the wounded, eat the dead

Title: Re: drilling question
Post by: stanski on October 21, 2005, 12:00:42 AM

Can you? Yes.

Should you? Well, seeing as how it is ABSOLUTELY MEANINGLESS to put a pin in a position when you have no idea of your pap, and just as meaningless to place an mb, I'd say you'd be better off just closing your eyes and sticking holes wherever they may fall (am I being too harsh with them? I just so wish I could be as polite in my answers as some other users yet get my point across).
--------------------
stanski

Title: Re: drilling question
Post by: stormerjip on October 21, 2005, 12:05:57 AM

i know my pap  its 4 1/2 over and 1/4 up
--------------------
show no mercy, kill the wounded, eat the dead