Can I put a flare decreasing X-hole in my Awesome Finish? It moves similar (I mean similar not the same) as my Ntense but I need something below this motion because sometimes at the 3rd game I can't put the Finish in the pocket. Now, I know that Morich recommends putting Xholes from pap (p1) to MB (p4). The question is if I can put a flare decreasing hole 2 1/4 in above my pap, will I obtain what I want? I want the ball to be longer and controllable for drier lanes. The ball is drilled pin above and to the right of ring finger, cg and MB stacked, MB like 1 in right of thumb. I have med-high speed, revs and track.
Thank you in advance.

Thanks 8t, what size of drill would you use and where should I take the side weight, 1/8 neg, 3/4 neg? in order to decrease motion and strength.

You have a MoRich ball, why not use Mo's Gradient Line balance hole system?

Brunswick's system of putting the X hole above/below or inside/outside the PAP was originally intended for their symmetric cores.  For a strong asymmetric, I'd suggest sticking with something designed for them.

I have a Black Widow Bite.  The ball reaction wasn't quite what I was looking for.  After watching BrunsNick's video, I talked my driller into adding a flare increasing hole outside of my PAP.  It made no noticeable change in the ball's reaction.  I had that plugged and used Mo's system since the core is asymmetric and I'm much happier.

Also, your description of where the pin, CG, and MB mean absolutely nothing.  Especially with a high mass bias ball, they must all be measured from your PAP.
--------------------
Penn State Proud

Ron Clifton's Bowling Tip Archive