BallReviews

Equipment Boards => MoRich => Topic started by: BrunsMAC on May 02, 2005, 09:12:01 AM

Title: Minotaur Drilling
Post by: BrunsMAC on May 02, 2005, 09:12:01 AM

I am getting a used minotaur and I am wondering what a good drilling would be for this ball. Medium track, I want a sharp breakpoint.

Title: Re: Minotaur Drilling
Post by: BrunsMAC on May 02, 2005, 06:28:24 PM

Anyone?

Title: Re: Minotaur Drilling
Post by: livespive on May 02, 2005, 06:39:16 PM

http://www.morichbowling.com/Minotaur/InfoSheet.htm

Pin 3-3/8 from papr and 2 1/2 from VAL
RC 5 from pap and 1 from val
--------------------
Eric T. Spivey, P.E.
 Visionary Test Staff Member
http://www.visionarybowling.com
http://www.maysbowlingandbilliards.com

Edited on 5/2/2005 6:33 PM

Title: Re: Minotaur Drilling
Post by: livespive on May 02, 2005, 07:04:28 PM

Message sent
--------------------
Eric T. Spivey, P.E.
 Visionary Test Staff Member
http://www.visionarybowling.com
http://www.maysbowlingandbilliards.com

Title: Re: Minotaur Drilling
Post by: BrunsMAC on May 02, 2005, 09:35:53 PM

Thanks Livespive