BallReviews
Equipment Boards => MoRich => Topic started by: REVOLUTIONS PS on October 26, 2009, 09:49:17 AM
-
I've been out of the pro shop end of the business for a couple years now as I've moved into centre management but I still know my way around the drill press. However, I drilled a customer of mine a Morich LevRG with a label-type drilling, pin next to the ring finger (which is about 5 1/2" from his axis) and the MB was in his track. The ball rolled over the middle finger and I was wondering if anyone else has had this problem with this particular ball.
-
You don't put the MB of a strong asymmetrical ball in the track. It may reverse the flare, which is probably what happened.
--------------------
Where is the bait? I'm goin' to jail!!! - Chocolate GAYzer
-
I would agree with what was said almost 80% of the time
-
hey john! yea your mb is too close to his track.
--------------------
Timothy @Juniors Pro-Shops
LaSalle, Quebec-Located inside Pont Mercier Lanes.
Edmonton, Alberta. -Located inside Ed's Rec Room.(WEST ED MALL)
Keep them honest!
Ebay store updated very often: http://stores.ebay.com/gumby3170?refid+store