I’ve been trying to figure out how much stronger the S&D would be versus my WMB in the oil. I never really put much thought in it, but I couldn’t figure out why my WMB was so condition specific. Then I realized it after I measured the layout. Its 2 1/8" X 5" MB pin 2 1/4" above midline, MB 2" past VAL. To me that sounds like an early roll control drilling, does it not? I guess that may explain why I’m able to play in the oil, but have nothing left for the backend.
The S&D should be a huge step up from the WMB, especially drilled 3 3/8" X 5 1/4" MB.
Should I go pin above midline 2 1/8†or 3� Morich told me 2 1/8" pin above midline, but I still think the lower pin position might roll too early, then again, it might skid too far (having a problem with this) if I go 3".
How can I compare it to my Total Shock? 4" X 5 1/2" MB, pin 3" above the midline.
Edited on 12/13/2005 1:14 PM
