BallReviews

Equipment Boards => MoRich => Topic started by: chuck on January 13, 2006, 11:03:03 PM

Title: Seek & Destroy MB
Post by: chuck on January 13, 2006, 11:03:03 PM

I have a 15.4 ball and the MB is in a weired spot.
Trying to see what would be a good way to drill for max hook.
PAP is 5 1/8 right and 1/2 up.

 This is how pin locations are now.

     0 Pin

     0 CG Pin is 3 inches up

           0 MB is 9 inches right of CG in a 3.30 position.
               
Thanks chuck

Title: Re: Seek & Destroy MB
Post by: Mayhem on January 14, 2006, 07:31:22 AM

It might be easier to suggest a drilling if you could possibly post a picture of the ball showing the positions.

Title: Re: Seek & Destroy MB
Post by: chuck on January 14, 2006, 03:54:12 PM

I don't have the equipment to do the picture taking.
 But if you are looking at the ball like the face of a
clock,the CG would be in the center of the clock and the pin
would be 3 inches above it at the 12.00 position.

 Now go over toward the 3.00 a clock position 9 inches which
puts you past this position. Then measure down toward the 3.30 position,
and this is where the MB mark is.