BallReviews
Equipment Boards => MoRich => Topic started by: monstercrank on December 02, 2004, 11:31:38 AM
-
IF I WERE TO GET ONE, AND HAD IT DRILLED FOR AGRESSIVE BACKEND HOW MUCH SHOULD I EXPECT ON A 1 CRAPPY TO 10 AMAZING
I AM A CRANKER
ALSO WHAT WOULD BE A VERSITAL PIN AND TOP WEIGHT BE FOR A CRANK WITH LOTS OF SIDE ROAL
Edited on 12/2/2004 9:15 PM
-
honestly I have got one drilled and another on the way. I have to tell you if you dont have the ball speed its not a good ball. I mean you will see a very big reaction. Its good through the mid lane and then the back end its going to flip hard. I would suggest though that if you have a slower ball speed that I wouldnt use it.
GREAT BALL
AS FAR AS PIN AND ALL. ANY OF THE NORMAL PINS OR TOP WEIGHTS. THIS BALL WILL FLIP HARD IF IT TOUCHES ANY DRY BOARD.
-
I AM BY ALL MEANS NOT THROWING SLOW BUT, WHAT DO YOU CONSIDER SLOW
-
I refer to slow as probably as around 10mph . I think most who throw this maybe have around 15 to 20. I mean if you throw it hard then it will work for you
-
ok thanks,
but you cant be serious about the pin, any size?
-
to be honest, I havent seen a person yet say anything bad about the pins. I mean the normal "pins" maybe 1" to 2 are the best. But everyone who has any of these pins says they are awesome. I am not sure about anything beyond 2.5 since most that are sent to us are in the before stated pin lengths. Sorry if this is vague
-
well now i am a little worried. i just bought one from buddies like 10 min ago and requested a 2-3 in pin and 3 oz top weight. i thought it would be more versital
-
Mine is drilled 3-1/2 x 5-3/4 x 2-1/2, with a 4" pin. After throwing it a game or two it seemed to read and move a little earlier than I wanted. I took the cover up to 800 grit and got more length and a hard turn on the backend, not flip but a very angular turn more than I had expected have moderate speed 15-15.5 with a med to med high rev rate, the WMB is very predictable with a smooth angular motion at the breakpoint.