Author Topic: Need Help Drilling a NIB Hole Pounder Pearl (Read 1301 times)

renoatpikeville · « **on:** December 12, 2006, 08:37:17 AM »

I just got a 15# Hole Pounder Pearl 4.5" pin 3 oz. top...I need help deciding how to drill it.

My Specs:
Left-handed
15.5-16.5 ball speed
300 rpm
PAP: 4.5, .25 up
tilt 30 degrees

I would like your help so anyone with a Hole Pounder Pearl please input.

Thanks

MegaMav · « **Reply #1 on:** December 12, 2006, 05:04:59 PM »

dont know too much about the ball, but the specs would be a perfect canidate for PIN on PAP with CG on center of grip, especially if you're a higher rev player.

it should be smooth as butter.

MegaMav · « **Reply #2 on:** December 12, 2006, 05:05:30 PM »

or even rico it, the weight hole would be centered on the CG.

renoatpikeville · « **Reply #3 on:** December 12, 2006, 05:09:55 PM »

Mega Mav

rico sounds good...45 degree drill, pin on center grip? weight hole 6 3/4" in a straight line from pin right?

thanks for the help

Edited on 12/12/2006 6:10 PM

MegaMav · « **Reply #4 on:** December 12, 2006, 05:58:03 PM »

when i spoke to Ric about that, he told me (regarding zone classic) that it should be the same distance down from the pin on the 45Â° line as your PAP is over from your center of grip, i think that hole at 6 3/4" will be stronger than the 4 1/2" i am talking about, i think it will raise the bow tie higher as well, would need confirmation on that.

Eric

MegaMav · « **Reply #5 on:** December 12, 2006, 05:59:58 PM »

http://members.fortunecity.com/megamav/bowling/html/rico.htm

Author Topic: Need Help Drilling a NIB Hole Pounder Pearl (Read 1301 times)

renoatpikeville

Need Help Drilling a NIB Hole Pounder Pearl

MegaMav

Re: Need Help Drilling a NIB Hole Pounder Pearl

MegaMav

Re: Need Help Drilling a NIB Hole Pounder Pearl

renoatpikeville

Re: Need Help Drilling a NIB Hole Pounder Pearl

MegaMav

Re: Need Help Drilling a NIB Hole Pounder Pearl

MegaMav

Re: Need Help Drilling a NIB Hole Pounder Pearl