BallReviews

Equipment Boards => Roto Grip => Topic started by: Strapper_Squared on November 24, 2013, 01:36:01 PM

Title: defiant edge surface?
Post by: Strapper_Squared on November 24, 2013, 01:36:01 PM

I drilled up a Defiant Edge as a compliment to my Green Mamba.  Was looking for a little more length as the lanes begin to transition.  Threw a few games today, and the Edge was reading just a touch too early for me.  I looked at the box finished, stated to be 1500 polished.  I think this is actually 500/4000 with polish?  What is a step weaker from this?  1000/4000 and polish?  Or 500/1000/2000 and polish?

Thanks

Scott

Title: Re: defiant edge surface?
Post by: billdozer on November 24, 2013, 02:17:28 PM

Its the same for every ball they make that is 1500 with polish


500/1000/2000/4000 plus polish

Check the bottom of the iq tour tech sheet on this forum post...

http://www.ballreviews.com/storm/iq-tour-fusion-t297842.45.html

Title: Re: defiant edge surface?
Post by: Aloarjr810 on November 24, 2013, 02:31:13 PM

Here's the steps Bill is referring to:

Storm 1500-grit Polished Factory Finish
1. 500-grit pad – Sand firmly for 30 seconds on all four sides.
2. 1000-grit pad – Sand lightly for 20 seconds on all four sides.
3. 2000-grit pad – Sand lightly for 20 seconds on all four sides.
4. 4000-grit pad – Sand lightly for 20 seconds on all four sides.
5. Storm® Step Two™ – Polish lightly for 15 seconds on each side.