I wonder if any of you guys can help me with some drilling/setup/surface advice for a Cell. I wish to use it on longer/oilier patterns and when there is carrydown.

Now I don't know my exact stats but I would say I'm a stroker that either plays a small-medium out and in shot usually somewhere around 1st/2nd arrow from about 5-6 boards left of that target(Can play further left depending on ball/conditions) or straight up the boards (ala WRW & Norm Duke). I am medium speed/Revs bowler and I would say my track is high-ish.

If any of you guys could help I would appreciate it very much


--------------------
I would have got away with it if it was not for those pesky kids (Behind my lane) and those blasted 10 pins.

Unfortunately despite my reasonably decent average I still don't know my exact stats. I think part of this is that I have never wanted to over complicate things and also I probably buy a new ball every 3-4 years so have not felt it was that important in the past.

My driller is going to measure my PAP just before I get the Cell,I was just interested in general opinions on how strong I should get a drilling/what surface/layout I should use,especially from those who are either strokers or low end tweeners.
--------------------
I would have got away with it if it was not for those pesky kids (Behind my lane) and those blasted 10 pins.

Put the Pin under ur ring and Kick ur mass bias out 3 inches from ur thumb.
and a with hole 1 inch below the mass bias.
 
to make this drilling more aggressive. take the grit down to six hundred.

I drilled mines lke that and the first time i used it i shot 730 scratch.