Whats the pin to pap on that?

My Neptune has the OOB surface...

For me with a 5x5 pin over ring stacked over the CG layout it gets easy length, at times too much and makes a pronounced turn to the pocket.  

Looking at the core numbers and the cover it reacts a little more than I'd like it too.  It can be a little strong off the spot on fresh backends.  However this ball hates any site of carrydown or longer oils.

Compared to my Mercury drilled with the pin under the ring and the CG right an inch it is longer and stronger.  The Mercury is clean and smooth and even reacting down lane.  I prefer it to the Neptune because I know what it is going to do when I throw it.


--------------------
With every action, there comes consequence


Used to be known as Pin_Krusher or Divine_Dragon




Edited on 9/13/2008 1:19 PM

thanks guys, if its too flippy i may just take the polish off
--------------------
RYAN MCDANIEL...University of Wisconsin Whitewater Men's Bowling...5th place at nationals in 07/08

www.newballz.com/forum
great new website!!!

FOS!!!

Diamonds...she'll pretty much HAVE to!!!

ryan, most likely the same as a dick weber 5 star.
--------------------
Michael Nelson
Northern Illinois University Bowling

rymacath, it probably will go a little longer and be a little more on the backend. But you won't know until you try it

I have a neptune that I will be drilling up some time and I was trying to come up with a drill to put on it. Stats in profile. I was thinking a 5 x 5 over the fingers(no hole) or a 4 1/2 x 4 1/2 with an extra hole 1 inch below my pap to smooth it out some. What do you guys think? Any suggestions?
--------------------
If your going to bowl...bowl for fun or go home