Author Topic: need surface suggestion for mutant cell (Read 1002 times)

mediumrevs15 · « **on:** January 08, 2010, 11:18:40 AM »

the 2000 grit oob finish snaps to hard on the backend and is hard to keep off the nose.

brought the surface down to 1000 grit and ball is now easy to get to the pocket but leaves countless 10 pins.

now should i leave it at 1000 grit and add some ebonite factory finish polish or try 4000 grit abralon pad?

ball is drilled stacked with pin by ring finger, cg kicked in a tad under ring finger and rg line up with pin by thumb.

thanks

Zack Pelton300 · « **Reply #1 on:** January 08, 2010, 09:49:50 PM »

try taking it down to 4000. If that does not seem to work you could try polishing it, or polish it then go over it lightly with a 2000 pad for a short time.
--------------------
Zack Pelton
Olathe, Kansas
Ebonite Amateur Staff
Ebonite Bowl 2 Win
www.ebonite.com

joblo1978 · « **Reply #2 on:** January 13, 2010, 11:29:42 AM »

I hit mine with some storm ultra shine I think it is. Probably the 3500 equivalent. I did it by hand and it mellowed it out a bit.

42swaff · « **Reply #3 on:** January 13, 2010, 01:15:40 PM »

try 1000 ab pad to adjust the surface , then hit it with rough buff finish should do the trick

Author Topic: need surface suggestion for mutant cell (Read 1002 times)

mediumrevs15

need surface suggestion for mutant cell

Zack Pelton300

Re: need surface suggestion for mutant cell

joblo1978

Re: need surface suggestion for mutant cell

42swaff

Re: need surface suggestion for mutant cell