BallReviews

Equipment Boards => Roto Grip => Topic started by: r534me on August 31, 2009, 05:00:30 PM

Title: Opinions on drilling a Cell to be an oiler
Post by: r534me on August 31, 2009, 05:00:30 PM

I have a pin up VG that goes a little longer than I like on the left side.  I just won a Cell with a long pin 4.5 - 5 inch pin.  How would you drill the Cell to be an oiler?  Not sure of my rev rate but it's higher than a stroker.  My Pap is 5 1/4 and 1 1/6 up.  I looked at 5x3 and 4x4 drillings for oil.  There is also dual angle drillings too.  To make things complicated I purchased a T-road solid that I plan on going pin under.  

That brings me to another question.  Will they compliment each other or will there be any overlap?  Also, I have a 2D at 2k pin up.  I guess my equipment will be angular and rolly?

Any comments appreciated.

edit: rushed the initial post


Edited on 9/1/2009 1:55 AM

Edited on 9/1/2009 6:11 PM

Title: Re: Opinions on drilling a Cell to be an oiler
Post by: tloy on September 01, 2009, 10:45:40 AM

Drill the Cell 4X4 Pin Up or down your choice... You will not be disappointed.
--------------------
Todd Loy
Roto Grip King of Them All!!!!

Title: Re: Opinions on drilling a Cell to be an oiler
Post by: jbuzz31 on September 01, 2009, 10:59:04 AM

Id go 4x3
--------------------
Ive Eaten From The Insane Root That Imprisons Reason

Title: Re: Opinions on drilling a Cell to be an oiler
Post by: laddog54 on September 01, 2009, 01:16:22 PM

My Cell has a 4in pin and is drilled 4X4 with the pin above the fingers. One the Shark, USBC, and heavy THS is works great. It doesn't hook a ton but reads the lane, finishes with a nice little arc and carries.
--------------------
ROTO GRIP - King of Them All

Title: Re: Opinions on drilling a Cell to be an oiler
Post by: r534me on September 01, 2009, 06:12:34 PM

Thanks for the tips.  I look at them both and see if it's possible with the pin, etc.