Author Topic: How to drill my new Rogue for the USBC?? (Read 841 times)

MuncieBowler · « **on:** March 20, 2009, 06:32:12 AM »

I just received my Rogue yesterday and it has a 2.5 inch pin. I am right handed and I have average speed 13-17 mph which is a a guess. I have average to a high rev rate. I was just wondering what has been scoring at the USBC. Pins up down kicked out or what. I was wanting to drill mine pin down under my ring finger kind of like my old total NV was drilled. I something strong because in my bag will be a Attitude Shift drilled negative. A Epic Quest with mid palm cg and pin at a one oclock position on my ring finger. And then a mars drilled pin at 12 oclock.

I know this is very little information but if anyone has an idea anything would be helpful.
Thanks

Chris O.
muncie indiana
--------------------
USBC Nationals April 20th and 21st.

laddog54 · « **Reply #1 on:** March 21, 2009, 10:53:48 AM »

I am drilling mine Rico. I wan't to make sure it's consistant, reads the pattern and has some pop in the back. If it's too much in the back I have the original Cell and if it reads too early I have the Pearl.
--------------------
http://www.allbowling.com/journal/public.php?uid=4002&leagueid=2552
http://www.allbowling.com/journal/public.php?uid=4002&leagueid=2587
http://www.allbowling.com/journal/public.php?uid=4002&leagueid=2715
ROTO GRIP - King of Them All

Author Topic: How to drill my new Rogue for the USBC?? (Read 841 times)

MuncieBowler

How to drill my new Rogue for the USBC??

laddog54

Re: How to drill my new Rogue for the USBC??