win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: Looking for right ball  (Read 1494 times)

JustinM

  • Full Member
  • ***
  • Posts: 156
Looking for right ball
« on: September 28, 2003, 10:51:26 AM »
What I am looking for is a ball that has a smooth arc to the pocket in the mid-lane that is good on a dry short pattern with flying backends. My other equipment goes long and snaps way too much. I got some foward roll but have med to high revs so overall the hook is a lot. I was mostly wondering if the sonic x solid would work and which drilling layout i should use.
Logged

 

Jeffrevs

  • Hero Member
  • *****
  • Posts: 11890
Re: Looking for right ball
« Reply #1 on: September 29, 2003, 07:13:07 AM »
Justin........yes, the Sonic X Solid is definately what you're looking for!  Both the original and the solid would work.  Although the original Sonic isn't a skid/snap ball, it's a bit snappier than the solid.  With your med/high revs w/ forward roll, I'd go with something like a 4 1/2x4.

Roger at RotoGrip says not to worry about drilling these Sonics too strong,...w/ the low differential, they will still be controllable...good luck
--------------------
JEFF
"How do you chop the 10 off the 6 ?!?!?!"
Logged

charlest

  • Hero Member
  • *****
  • Posts: 24526
Re: Looking for right ball
« Reply #2 on: September 29, 2003, 07:37:36 AM »
If the pattern is dry and short and you have med to high revs, while the Sonic solid may be the best RG ball, you may still need to sand it dull to 1200 - 2000 to allow it to burn up some in the mdilane in order not to produce an extreme hook in the backend. Experiment with the stock cover and if there's still too much backend, try sanding it very fine.
--------------------
"Those who do not remember history are doomed to repeat it."
Logged
"None are so blind as those who will not see."

Jeffrevs

  • Hero Member
  • *****
  • Posts: 11890
Re: Looking for right ball
« Reply #3 on: September 29, 2003, 07:47:59 AM »
quote:
If the pattern is dry and short and you have med to high revs, while the Sonic solid may be the best RG ball, you may still need to sand it dull to 1200 - 2000 to allow it to burn up some in the mdilane in order not to produce an extreme hook in the backend. Experiment with the stock cover and if there's still too much backend, try sanding it very fine.
--------------------
"Those who do not remember history are doomed to repeat it."


Justin....YES !! Good point "Wise One!"  This ball does come box,...1500 polished.............
--------------------
JEFF
"How do you chop the 10 off the 6 ?!?!?!"
Logged

JustinM

  • Full Member
  • ***
  • Posts: 156
Re: Looking for right ball
« Reply #4 on: September 29, 2003, 06:38:44 PM »
Thanks for all the advice and the sonic x solid will be the next ball i buy for sure.
Logged
Pages: [1]
« previous next »