Jeffrevs has been great about giving me info and advice on the Rotogrip line, and I am going to be getting a Sonic X solid soon. Anyway, I have a question about the drill pattern to use. On the drill sheet which I printed off from their website, they show the pin placement, and 3 different MB locations and a brief description of what to expect from each of those drillings. Specifically, I am thinking about drilling "A" - however, I notice that by placing the MB in location a and c that the description is similar. Both have a length rating of 10, and backend reaction rating of 3. a) says and arcing reaction vs b's controlled reaction. Can you tell me the difference of how the arcing reaction will look on the lane vs the controlled reaction? Which one will have the a sharper breakpoint?
Here is some info on me - it's as specific as I know how to be.
Right handed. Track on non-flaring equipment is approx. 1/2 in from finger, and 1/4 inch from thumb. I estimate my speed to be average, with above avg. revs - most likely the upper end of avg. revs to lower end of high revs. I'm wanting this ball primarily for dryer conditions - possibly for when the backends are really clean and moving hard. Looking for a more even reaction, less skid/snap. Is this possible with this drilling? Any suggestions would be greatly appreciated.
This will hopefully fit between my urethane Scout, and Stinger LF (which is drilled to go looong then HARD arc).
--------------------
9~Yawn! Did you say something?
