Needing some help here.

 

I have a Raging Bull Charged drilled 35x4 1/2x70 or roughly pin under ring finger mb out about 2 inches or so. and it is not nearly as strong as I had hoped or imagined, actually tonight on Tokyo Pattern this ball hardly budged in oil. Used RBC on a THS last week and it had less than expected their also.

 

My question is has anyone messed with this cover yet? If so what did you do and what did you see from the changes? I think my ball speed is just a to much for the OOB surface and drill pattern combination.

 

I am going to take it down to 360 abralon to start then put Motiv Gel Polish and try that first I have had sucess doing that in the past but I am still looking for other ideas if you got any let me know.

Sorry bud no such luck I think just the volume of the pattern was a little to much for the ball. I made surface change dulling it down to about 360 then polished it again and it is beast. Carries like a dream also.

 

If you can pick one up from somewhere I would recommend it.