BallReviews

Equipment Boards => Storm => Topic started by: sportbowler on May 15, 2005, 10:51:34 AM

Title: Ace and Vertigo drillings ?
Post by: sportbowler on May 15, 2005, 10:51:34 AM

I am new to storm balls and I am not sure how to get them drilled and I would enjoy your help.

For the Ace I was planing On getting it drilled with the pin up or with then pin over my ring finger.
=@=      
0=0    
===
===  
=0=      
==rad    

or

==@
0=0
===
===
=0=
I would like to know how the reaction would change from the pin up to the pin over my ring finger.And do you think that these drillings are good for medium to heavy oil.

For the Vertigo I was planing on getting it for heavy oil, and for the drilling I was thinking of getting the pin to the right of my ring finger. That was how I had my Ultimate Inferno Drilled and Is this a good heavy oil lay out.

0=0=@
====
====
=0==

My revrate is Medium(at kegal Traning center it was 250rpm )
My Ball speed is medium(around 15mph)
Lanes surface is Synthetic
I am not sure exactly sure what axis tilt is but I think mine is 25 degrees(The tilt of my hand at release or at the start off) I am most likely way off what it is but o well.

Thanks Again



 


Edited on 5/15/2005 6:58 PM

Edited on 5/15/2005 7:25 PM

Edited on 5/15/2005 7:41 PM

Edited on 5/15/2005 7:41 PM

Edited on 5/16/2005 12:50 PM

Title: Re: Ace and Vertigo drillings ?
Post by: Billy Ray on May 15, 2005, 07:18:05 PM

Whats your rev rate? Tilt? Axis? Ball speed? Lane surface?
is this for tournaments or leagues?
--------------------
Billy Ray

Title: Re: Ace and Vertigo drillings ?
Post by: sportbowler on May 15, 2005, 07:36:59 PM

I looked at the ones on Storm's Web site and they aren't any help to me.
--------------------
NOTHING LIKE A STORM BALL

Title: Re: Ace and Vertigo drillings ?
Post by: jimmy on May 26, 2005, 10:01:08 PM

I have my ace drill with pin up and between the bridge and the cg kick out to the right with a balance hole.  The rad is 2inch to the right on my thumb hole.

This ball work great on med-heavy oil but very conditional drilling need oil for this drilling.