win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: Ball slection  (Read 769 times)

Spit_Fire

  • Full Member
  • ***
  • Posts: 182
Ball slection
« on: November 29, 2008, 05:22:08 AM »
Hello, I recently drilled up my old specail agent as a test ball for my new span, also I selected a unusual drill for it. It is drilled 6 x 4 ( thats pin under middle finger for me). My axis is 5 1/2 over 1/2 up. The X hole is drilled 4 3/4 over 1/2 down from my axis. It is 1" Dia, 3" deep. I bowl on wood for tournaments and synthetic for leagues. This ball reads really  well on the cheetah and chameleon. Im looking for the same consistent ball reaction but, something stronger. Any suggestions
Logged

 

Stormkid84

  • Full Member
  • ***
  • Posts: 149
Re: Ball slection
« Reply #1 on: November 29, 2008, 01:59:34 PM »
I would go with a dimension or a Virtual Gravity.  I have an Attitude Shift drilled the same way and rolls very nice on the scoripion and viper, not bad on the shark either.
--------------------
Me: "These lanes are tight. I have 2 boards!"
My buddy with front 8: "Me too!"
Me: "Yeah, but yours both have arrows on them, and an arrow in between!"
Logged

Spit_Fire

  • Full Member
  • ***
  • Posts: 182
Re: Ball slection
« Reply #2 on: December 01, 2008, 08:44:21 PM »
I have a Hy-road comming tommarow I want to drill it for harder flatter conditions. Right now I only have that and my Specail Agent ( you can see drilling above ). I was planning on going pin under bridge on this one ??? any input
Logged
Pages: [1]
« previous next »