Author Topic: IQ tour Nano - Help (Read 2419 times)

Rawad · « **on:** June 02, 2015, 02:54:45 AM »

I have been using IQ tour nano for a while, the ball is amazing yet I think I still can't get the most out of it because of the big angle I create due to my high rev and relatively average speed, basically I need a little bit of push down lane, so is it okay to polish the IQ tour nano and make shine, or would that affect the coverstock in a bad way.

Thank you

spmcgivern · « **Reply #1 on:** June 02, 2015, 07:54:58 AM »

People have had success in going with a higher grit on their IQTN. The OOB is 4000 grit so depending on what you have to work with, just go a bit higher from there. Could be a worn 4000 pad or light polish. For me, I don't make too big a jump when changing surfaces. I usually make incremental changes till I find the sweet spot.

freak761 · « **Reply #2 on:** June 02, 2015, 09:19:06 PM »

Use a 3000 or 4000 abralon for 20 to 30 seconds on the spinner. The IQTN comes with a 500/4000 finish, 30 seconds with a 500, 5 seconds with a 4000 so it is very aggressive OOB.

mrwizerd · « **Reply #3 on:** June 03, 2015, 03:29:07 PM »

I have an IQ Tour Nano with a pin over ring with the CG kicked out layout and OOB surface, but I didn't like the reaction I was getting. I took the surface to 500 and then applied some polish and it definitely changed the look for the better (for me).

I don't know if this answered your question, but it can show that polish can change things for the better or worse (had that happen before).

Rawad · « **Reply #4 on:** June 04, 2015, 05:13:11 AM »

Thanks Everyone, all of that was helpful, I ended up polishing it and I had a great back end reaction, now it's more controllable and carried very well on light hits, I just loved it this way.

Author Topic: IQ tour Nano - Help (Read 2419 times)

Rawad

IQ tour Nano - Help

spmcgivern

Re: IQ tour Nano - Help

freak761

Re: IQ tour Nano - Help

mrwizerd

Re: IQ tour Nano - Help

Rawad

Re: IQ tour Nano - Help