Author Topic: Soniq question (Read 2259 times)

tloy · « **on:** October 26, 2018, 03:29:05 PM »

I had a Marvel pearl crack out on me. Storm replaced with a Soniq. What should I expect out of this compared to the Marvel pearl? I am a little hesitant as I have a hyroad that I have not matched up with. Drilling and surface advice welcome. Thank you

AlonzoHarris · « **Reply #1 on:** October 26, 2018, 05:12:40 PM »

Cleaner and sharper on the backend than what the Marvel Pearl was.

You could break the Polish with a 4000 pad and help get the cover closer to the R2X cover. Pin-PAP distance could stay the same as the Marvel Pearl and I would personally add 10-15 degrees to the VAL angle to round it out a bit more. This is all of course if youâ€™re hoping to get the Son!Q as close to the Marvel Pearl as you can.

tloy · « **Reply #2 on:** October 26, 2018, 05:54:24 PM »

Thank you for the reply. Why would you add 10-15 degrees to the Val angle? Is this to smooth it out?

AlonzoHarris · « **Reply #3 on:** October 26, 2018, 07:15:10 PM »

Quote from: tloy on October 26, 2018, 05:54:24 PM

Thank you for the reply. Why would you add 10-15 degrees to the Val angle? Is this to smooth it out?

Pretty much, and thatâ€™s probably a leave it or take it kind of thing. Breaking that polish on the Son!Q will help with that more so.

tloy · « **Reply #4 on:** November 02, 2018, 12:21:38 PM »

Decided to try out of box. Wow!!! Stronger than my Marvel Pearl . Will defiantly have to sand the cover some..

Author Topic: Soniq question (Read 2259 times)

tloy

Soniq question

AlonzoHarris

Re: Soniq question

tloy

Re: Soniq question

AlonzoHarris

Re: Soniq question

tloy

Re: Soniq question