win a ball from Bowling.com

Author Topic: Heat Lava  (Read 5792 times)

BallReviews-scodaddy21

  • Administrator
  • Hero Member
  • *****
  • Posts: 974
Heat Lava
« on: July 10, 2019, 10:46:32 AM »
Ball NPS Score: 100.00
bowling.com has the largest selection of bowling balls
Click here to shop.

Track continues the success of the Heat bowling ball line with the Track Heat Lava. This ball creates easy length through the front of the lane and then generates more motion from the midlane on. This ball takes the QR-7 Pearl coverstock with a polished finish and wraps it around the Modified Tri-Core to offer more versatility allowing it to pair well with medium as well as lighter oiled lanes. The medium RG and low differential found on this ball allow it to store enough energy for the backend and keep its reaction consistent and predictable roll after roll.

Color: Lava Sparkle
All colors do vary somewhat from the picture shown
Coverstock: QR-7 Pearl
Core: Modified Tri-Core
Finish: 500/1000 Abralon Polished w/ Powerhouse Factory Finish Polish
RG: 2.50**
Differential: .038**
** RG and Diff are based off of 15 lb. balls
Reaction: Length with Continuous Backend
Recommended Lane Condition: Medium to Light Oil

 

ronaldhjr

  • Full Member
  • ***
  • Posts: 165
Re: Heat Lava
« Reply #1 on: August 02, 2019, 08:39:49 AM »
Heat Lava – Various sport and house patterns

Positive Axis Point 4 3/8 right 1/2 up.

Finish through the pins is amazing for me, maybe it’s the layout or maybe it’s the lane surface(s).  I have bowled at four different bowling centers and the drive through the pins when using the Heat Lava is amazing.  I tried to box surface on a fresh house pattern, the ball roll seemed normal (normal pearl reaction for me length (skid), sharp or arcing of the friction).  The finish through the pins for me was different then any Heat I have used prior to this one.  I had to put a little surface on the cover to see if the finish would change.  2000 pad roll was a little earlier but not drastically early.  The finish through the pins was amazing (need I say it again).  The Heat Lava is a bowling ball I will go to when I cannot get that drive I want through the pins on conducive lane patterns.  The surface I have played with so far are 500/3000, 1000/4000, 3000/500/1000, and finally 4000.  The Heat Lava has taken the surface adjustments well, having the lower grit surface on the Heat Lava made it respond earlier but, it didn’t lose its drive through the pins.  The Heat Lava is a great rolling pearl piece, for finish through the pins for me has me sold!!!  I went pin down between my bridge CG is swung out just a little.
Track Amateur Staff