win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: robo rule weight block...  (Read 641 times)

kc571

  • Jr. Member
  • **
  • Posts: 72
robo rule weight block...
« on: November 28, 2005, 07:14:58 AM »
As I'm learning more about weight blocks, a friend asked me a question that I could not answer.

Being that the Robo has a U shaped weight block, wouldn't it roll sooner because the weight is at the bottom of the ball?  What should this U shaped block do?

On another note, if I get this ball (which I'm close to doing), what can I use to shine it up a touch.

thx,
Vinnie
Logged

 

clintdaley

  • Hero Member
  • *****
  • Posts: 4246
Re: robo rule weight block...
« Reply #1 on: November 29, 2005, 06:44:03 AM »
I like Delayed Reaction to shine my stuff up with.

If you remember back to the Cudas and the other balls with the Ceramicore at the bottom of the block....it helped those balls really rev up and hit. I think the same goes for this as well.

Clint
--------------------
Clint Daley-Owner
Lets Go Bowling Daley
Inside Hunt Club Lanes
Salem, Ohio 44460
TRACK ADVISORY PRO SHOP STAFF

http://www.trackbowling.com/

http://www.startabowlingrevolution.com/
Logged









OG1

  • Full Member
  • ***
  • Posts: 200
Re: robo rule weight block...
« Reply #2 on: November 29, 2005, 09:45:14 AM »
I think that would depend on the densities of the the flip block. In this case it appears from the pictures(looking at the colors) that the density of the center piece of the flip block is less than the side pieces pushing more weight to the sides of the ball and not the bottom.
--------------------
Did they run the oil machine?  Was there any oil in it.....
Track Advisory Staff
Logged
Pages: [1]
« previous next »