How much difference should we expect between these two balls?  Both have the same finish and the same RG and Diff.

The LX05 looks good. 

Depends on your opinion of strength. I view it as overall strength which I would rank the LX05 a little above the MX.
With Track's system, the LX covers are stronger than MX which is stronger than HX when used with the same core

Depends on your opinion of strength. I view it as overall strength which I would rank the LX05 a little above the MX.
With Track's system, the LX covers are stronger than MX which is stronger than HX when used with the same core

Ok.  I have the LX and, in it's box condition. is fairly strong.  In fact, it's a little too strong for the dry lanes I bowl on and I've had to add polish to use it at all.  Sounds like the MX may be what I need to look into for my house.   

Thanks for the info.

For me the Mx05 is a good 5 & 3 right of the Lx05. Have them both drilled the same way. In releation to what the reaction difference is between the Lx, Hx, & Mx05's are, the Hx05 was a 5 & 3 move right from the Mx05. The length differrence is about 3 feet earlier for the Mx to the Hx and the Lx is about 5 feet earlier than the Mx.

That would be what I am saying, my Lx05 was taken to 1000 and my Mx05 is at 3000. I dont see a difference in ball motion. Just a difference on how much volume they handle and how much area they cover because of where they start up. The Mx05 gives me the same motion that the Lx05 does, only I can move right. The Hx05 gives me that same motion just less than the Mx05 and far less than the Lx05, my Hx05 was Box. If I stand in the same spot to strike with the Lx05, the Mx05 would be a light pocket hit to a 2-10 combo hit. the Hx05 in that spot would be a washout no doubt. Until the volume on the lanes lightens up. Then the Mx05 would start to be flush, the Hx would be the 2-10 combo and the Lx qould start being either through the nose or even a roll out motion that sits and leaves me ten pin after ten pin.

Just saying the kinetic core is the best rolling core EVER!!!...

I had the 505c2 and that ball rolled great every time down the lane. Had it drilled pin up 4" and pin down 5", both layouts lit up our house shot

For me the Mx05 is a good 5 & 3 right of the Lx05. Have them both drilled the same way. In releation to what the reaction difference is between the Lx, Hx, & Mx05's are, the Hx05 was a 5 & 3 move right from the Mx05. The length differrence is about 3 feet earlier for the Mx to the Hx and the Lx is about 5 feet earlier than the Mx.

Thanks so much.  That's about the best description I've ever had of how the balls react.  I ordered the Mx05 today and, for the time being, I will probably leave it in box finish.  By the way, I used the Track recommendation tool and it recommended the Mx05.

Thanks again.