BallReviews

Equipment Boards => Track => Topic started by: ecc0_9879 on November 10, 2009, 02:53:12 AM

Title: drilling suggestions 505c
Post by: ecc0_9879 on November 10, 2009, 02:53:12 AM

I am a high rev player looking for a diffrent look on this ball have a 505c 3-4 inch pin 3 oz top have a 715a drilled pin above bridge and mb below thumb give me some ideas what worked for u guys with this ball

Title: Re: drilling suggestions 505c
Post by: mw11x300 on November 10, 2009, 10:56:27 AM

I drilled mine 55 x 4 3/4 x 60 with x hole on PAP.  The ball is outstanding on everything but the extremes.  I am also a high rev, high ball speed player.

Title: Re: drilling suggestions 505c
Post by: ecc0_9879 on November 10, 2009, 11:01:54 AM

so layed out ur pin is above your ring and the mb is about an inch and a half from your thumb??

Title: Re: drilling suggestions 505c
Post by: racincowboy3 on November 10, 2009, 10:42:33 PM

I have the pin over the bridge and the mb out like 3 inches I think.  Drill #1 on the sheet.  I have seen a few different guys throw this ball with this layout rangeing in all different types of styles from crankers to strokers and this layout provides the best length and backend form everyone.  a lot of control with this layout too.  doesn't get jumpy off the spot either

Title: Re: drilling suggestions 505c
Post by: directdrill on November 11, 2009, 05:13:19 AM

I used one of my favorite layouts on the 505C:  5" x 3", pin over ring.  The MB is near the VAL and I placed the weight hole on my PAP.  This is my benchmark ball and the 505C is very smooth and controllable.
--------------------
Hook 'em Horns!

"Stats are for losers, I like winning games." - Will Muschamp, Texas Defensive Coordinator