BallReviews

Equipment Boards => Track => Topic started by: jodyk24 on February 10, 2005, 06:15:12 PM

Title: GP2 surface change
Post by: jodyk24 on February 10, 2005, 06:15:12 PM

What does Track suggest on what to use to change the surface on the GP2? Some say to use scotch pads and never sandpaper. Others have said Track recommends sandpaper over the Pads on Track equipment. Polish has been used and it does not seem that there is a problem with that on the particles. I know this been
posted before but not sure about the GP2.

jodyk24

Title: Re: GP2 surface change
Post by: C-G ProShop-Carl on February 11, 2005, 12:36:16 PM

jody,

I like to use scotchbrite pads on particles. That is just my preference.

I am not sure exactly what Track says to use, but I spoke with Del in the past and he told me that he uses scotchbrite. SO if the guy that designs the balls uses scotchbrites, that is good enough for me.

-EX-
--------------------
C-G Pro Shop (owner/operator)
Youngstown Ohio

Track Intl.-Amateur/Pro Shop Staff

Title: Re: GP2 surface change
Post by: Traumabill on February 11, 2005, 01:08:35 PM

Jody,

Carl is correct use Scotchbrite.  I recently attended a seminar with Del and he recommended Scotchbrite.  General purpose Sandpaper has a tendency to smooth the particles which may defeat the intended purpose.  Automotive Sandpapers (ones with aluminum oxide) work ok in a pinch...


Bill
Bowling Services Unlimited
www.bsuproshops.com