Author Topic: need help drilling havoc (Read 788 times)

Deep_In · « **on:** March 14, 2004, 11:57:40 PM »

My pap is 4 1/2 i'm a stroker my speed is around 15-17
mph. ball spec is 15.2 lbs 2-3 pin I'm thinking pin under
the ring finger mass bias near my vertical axis line or i should say
3 inches to right of the thumb...i want to use this on medium to heavy oil
what do you think guys....respond will be much appreciated. thanks

tenpinspro · « **Reply #1 on:** March 15, 2004, 03:18:19 PM »

Hey Solid 9,

That sounds good, I have my pin in the same position but I placed my MB past my val at 2.75 inches, this makes it stand up a little faster but remain very smooth throughout the lane with a very strong continuous arc. If you want it for med/heavy, you may not need to touch the cover yet, Excaliber, Aus Leftie, and myself had this ball moving quite a bit. If it doesn't respond as strong as you want, then take the surface down some to accommodate your oil thickness. Hope this helps...good luck.
--------------------
Rick Leong
Ten Pins Pro Shop
Track Pro Shop Staff
Vise Grip Staff

Deep_In · « **Reply #2 on:** March 15, 2004, 03:49:06 PM »

Thanks...Rick

Author Topic: need help drilling havoc (Read 788 times)

Deep_In

need help drilling havoc

tenpinspro

Re: need help drilling havoc

Deep_In

Re: need help drilling havoc