Post by: SnoopyCanBowl on August 05, 2006, 06:18:32 PM
Machine layout: 4 1/2 x 3 3/4 (mb at 5 o'clock), pin on ring finger, 1 in wide and 2 3/4 in deep balance hole.
Help on: Robo Rule, Mean Machine, Arsenal Artillery, and Desert Heat. All of them have a 3 inch pin.
Plan on drilling:
Robo Rule: 5 x 3 1/2, cg at 5 o'clock of ring
Mean Machine: 4 1/2 x 3 1/2, cg at 5 o'clock of ring
AA: 1 inch above ring finger, cg at 5 o'clock of ring
Desert Heat: 1/2 inch above ring finger, cg 1 1/2 inch from center grip.
Any sugguestion will be nice. I use the machine mainly for med-med light oil.
--------------------
Have Fun while You Can!!!!
Edited on 8/6/2006 2:13 AM
Edited on 8/6/2006 2:15 AM
Post by: SnoopyCanBowl on August 06, 2006, 11:56:47 PM
--------------------
Have Fun while You Can!!!!
Post by: Laybzz74 on August 06, 2006, 11:59:44 PM
It's late on Sunday ... give the TRACK gurus a little time to reply; they'll hook you up, no problem !!!
--------------------
Man, I LOVE this game; and I love it even more now that I'm using LEGENDS/LaneMasters equipment !!!
"Master the Lanes with Legendary hitting power" !!!
Robb in O'Fallon, IL 62269 (near Scott AFB)
LAYBZZ74@AOL.COM (Email and PayPal addy)
Post by: tenpinspro on August 08, 2006, 03:33:21 PM
That's not bad but when referring to asymmetrical balls (Robo and Mean) it's not the cg that is important. We must be careful of where we place the mass bias that becomes the most crucial after the pin placement. Replace cg with mass bias in your layouts for the Robo/Mean and that should be okay.
--------------------
Rick Leong - Ten Pins Pro Shop
Track Intl. - Amateur/Pro Shop Staff
Vise Inserts Staff
www.Trackbowling.com
See profile for Track Ball videos
*El Presidente of the Track Legion
Post by: Laybzz74 on August 08, 2006, 03:38:02 PM
--------------------
Man, I LOVE this game; and I love it even more now that I'm using LEGENDS/LaneMasters equipment !!!
"Master the Lanes with Legendary hitting power" !!!
Robb in O'Fallon, IL 62269 (near Scott AFB)
LAYBZZ74@AOL.COM (Email and PayPal addy)
Post by: C-G ProShop-Carl on August 09, 2006, 10:31:28 PM
As Rick mentioned, on the Robo and Mean Machine the cg location really does not mean much.
Do you plan on drilling the Robo to be your heavy oil ball? if so, I don't think you will want to place the pin 5 inches from PAP......especially if the Machine is your med-medlight ball.
-Carl
--------------------
Carl Hurd
C-G Pro Shop (owner/operator)
Youngstown Ohio
Track Intl.-Amateur/Pro Shop Staff
www.trackbowling.com
Tag Team Member #1
(tag team partners w/ Rick)