Hello all, I got a rule for my wife and it has a one inch pin. I know on the morpheous cores pin placement is not as big a deal but I was wandering if there is anything special I need to watch for other than the static wieghts. I believe the top wieght is also on the lower end also around 1 1/2 to 2 ounces. I want it set up for length. Any help appreciated as always.

Thanks, cooksey
--------------------
" Focus the next shot is critical"

AIM:johncooksey24

cooksey, are you getting it drilled for length and alot of backend or length and a control reaction down the lane?

The 1 inch pin should be alright. More than likely after drilling the top/bottom weight will zero or it may have a little bit of bottom weight. This could help the ball roll early.

If I were drilling it I would not be overly concerned with ending statics on the ball. With the proper surface prep and layout the ball will be able to do what you want it to.

-EX-
--------------------
C-G Pro Shop (owner/operator)
Youngstown Ohio

Track Intl.-Advisory Staff