BallReviews
Equipment Boards => Track => Topic started by: loose5682 on November 25, 2003, 05:13:04 AM
-
With regards to the two relatively new Phenoms (original and Unleashed) which would be closest to a Freak drilled like this...
0 0
x--pin
x--cg
0
x--mb
I believe this would be considered a "leverage" drilling...the reaction gives me good length with a hard almost snappy backend...decent length for a particle ball but definitely not that of a pearl ball. I was thinking of either of the two Phenoms or the new Warp Zone as a possible replacement for this ball. If I get the Warp Zone I would polish (and maybe redrill) the Freak for more length and snap...if I get either of the Phenoms (assuming them to be as angular as the current Freak) I would possibly end up with the Zone anyways (as the Freak is dying and i'd rather not sand a dying particle ball)
Any suggestions, comments, or kicks-in-the-rear would be appreciated much...thank you
--------------------
Andrew Loose
Illinois State University Men's Team