Yes, it is safe to do so. I had this discussion with Rick about a year ago. I have an old layout he sent me (if I can find it), and this ball moved more than any other ball I have seen a full roller throw.
--------------------
C-G Pro Shop (owner/operator)
Youngstown Ohio

Track Intl.-Amateur/Pro Shop Staff

Nah, I have to work. I am at Nationals next week so I have to work as much as possible this week.


--------------------
C-G Pro Shop (owner/operator)
Youngstown Ohio

Track Intl.-Amateur/Pro Shop Staff

Good luck to both of you guys!!!!

Clint
--------------------
Clint Daley-Owner
Lets Go Bowling Daley
Salem, Ohio 44460
TRACK ADVISORY PRO SHOP STAFF

Good Luck!!!  Hope to hear that you both did great.
--------------------
KYLE    

IF IT WILL, IT WILL...SO BE IT!!!

Hey Rev-O,

Like Ex states, you can drill for full rollers on the Morpheus cores without a problem.  Only thing to remember is to watch where you place the mass bias.  I drilled a few of them and I kept the mb on the right side of the grip while keeping the pin on the left.  I drilled one with the mb on the same side as the pin and it rolled earlier.

There's also the max flare drill which places the pin 10 1/8 from grip center with mb at 3 3/8 from grip center.  This is an old layout though, I haven't tried this one yet on a Morpheus.  You might want to check with Brian or Del to make sure this is still a useable pattern on our core.  Hope this helps...

Good luck tomorrow and represent, the Crew's behind you bud.
--------------------
Rick Leong
Ten Pins Pro Shop
Track Intl. - Amateur/Pro Shop Staff  
Vise Inserts Staff