Alright here is my reveiew of this ball and a question all in one. First off I have been back into bowling for about 2 years now. I used to bowl alot when I was younger. MAN, have things changed! I am a cranker with high revs and throw the ball around 16mph. I have been using storm balls since I started bowling but I was impressed with the way track balls hit. The ball is drilled with the pin under the ring finger cg in the middle of my span and hand with the mass bias kicked out right of the thumb and the cover is high polished. All I can say is this ball hits like a truck! It carrys just about everything. Unless I get around the ball to much then I tend to leave tens. I play out and in, not sure on the board #s though. I will say that the ball is very forgiving, if I get it a little to far out it makes it back and if I pull it, it tends to hold pretty well. The way this ball is drilled it goes long for me and makes hard left at the backend. I am very impressed with this ball, and it is a good compliment to my eraser blaze.
However I ran into a little problem, after using the ball for about 3 weeks the bridge cracked! I called up the guy who drilled it for me and he replaced it no problem! Now when I picked up the new one, it was drilled up a little differently. This time the ring is still below the ring finger, but the cg is kicked out to the right in the middle of my span, and the mass bias is below the thumb. The cover is once again highly polished. Now my question is, this going to change the way the ball hooks, is it still going to go long and turn left at the backend? Or will the ball be about the same? I appreciate any input anyone has, and thnaks for reading my review!
Eric
