Author Topic: REPLACEMENT (Read 1616 times)

ARROWS · « **on:** November 30, 2011, 01:28:51 PM »

Hi Guys. today i decided to clean my bowling balls only to find out that My Track 505A has a has a crack all around it. now would the 503C be good to replace the 505A or is there something else in Track current line up that would suit me better?

TWOHAND834 · « **Reply #1 on:** December 01, 2011, 06:50:29 AM »

Obviously the 503C will be the closest thing to replacing it if you stay with Track. Alot will also depend on the layouts of the two balls. Also depends on if you want something slightly weaker than the 505 or something slightly stronger. If you want something maybe a little stronger, then the 716C could be a good choice as well.

Peace doesnt always have to be silent.

ARROWS · « **Reply #2 on:** December 01, 2011, 07:32:50 AM »

Hi here is the layout to my 505A: http://i1227.photobucket.com/albums/ee423/ARROWSA23/505A-1.jpg

as u can see the crack started near finger holes & finish of between fingers & the Tumb

Edited by ARROWS on 01/12/2011 at 8:35 AM

Edited by ARROWS on 01/12/2011 at 8:36 AM

Curt_Dupre · « **Reply #3 on:** December 01, 2011, 03:23:25 PM »

503C could be the replacement, but definitely drill it a little weaker. I haven't seen you bowl, but you can put the pin above your bridge, and this could give you a close enough reaction. 503C is considerably stronger but by drilling it weaker, you can get a close enough reaction.

Trackbowling.com
Mccorveysproshop.com
Track Regional Staff

Author Topic: REPLACEMENT (Read 1616 times)

ARROWS

REPLACEMENT

TWOHAND834

Re: REPLACEMENT

ARROWS

Re: REPLACEMENT

Curt_Dupre

Re: REPLACEMENT