BallReviews
Equipment Boards => Visionary => Topic started by: bestbudzs24 on September 01, 2009, 06:07:54 PM
-
i just picked up a nib #16 pound 3-4 inch pin with 2.78 oz. of top weight. i have never owned or even seen one thrown. i am wondering how strong is this ball. i am looking for a ball to use on mediums to medium-light. is this ball a good choice for those conditions. for those of you that have thrown or seen this ball thrown how should i drill it up for the conditions mentioned. and what type of reaction can i expect. thanks in advance.
--------------------
" bowling is for one thing and one thing only to make money"
-
whats your pap?
-
havent had my pap measured in quite some time but im pretty sure its 5 up 1/2 over.
--------------------
" bowling is for one thing and one thing only to make money"
-
From what I know about the GG, with your rev rate, I'd say pin at 5" from PAP abover the fingers (would probably end up in the bridge are) and the CG stacked below in the palm, or slightly shifted to your PAP. Should, at OOB finish, yield good length and a snappier breakpoint for medium conditions and less.
--------------------
DizzyFugu - Reporting from Germany
Confused by bowling? Check out BR.com's vault of wisdom: the unofficial FAQ section (http://"http://www.ballreviews.com/Forum/Replies.asp?TopicID=74110&ForumID=16&CategoryID=5")
-
sorry i wrote that wrong its 5 over 1/2 up
--------------------
" bowling is for one thing and one thing only to make money"
-
my pap is 5 1/2 1/8 up. i have a 5 by 4 drill on mine and goes long and snaps on med light oil.