BallReviews
Equipment Boards => Visionary => Topic started by: daboyz on January 29, 2009, 07:21:47 AM
-
Just picked this ball up cause i missed my crimson executioner, i know this will make more of an arc but that's what i am looking for to not leave so many corner pins, any ideas for lay outs to make this ball a constant mover? Just roll through the heads and move into the pocket very smoothly is what i am looking for my is in my profile thanks for your input!
--------------------
DABOYZ
-
Keep in mind that this is a particle pearl urethane, not resin, if I recall correctly. Wait for those who have drilled one and take into account their release when considering their drilling. I'd suggest a relatively high pin position.
--------------------
"None are so blind as those who will not see."
Edited on 1/29/2009 6:01 PM
-
I drilled mine pin next to ring finger with the CG in grip center to angle the MB neck right of the thumb. This ball did anything except roll it was quite snappy down lane and I had a lot of over under problems with that layout. I might not be able to suggest what layout works but I can tell you what didn't.
--------------------
The original Pin Krusher