win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: Low Diff balls an somewhat high track  (Read 1058 times)

ShoreLefty

  • Full Member
  • ***
  • Posts: 181
Low Diff balls an somewhat high track
« on: December 08, 2006, 03:34:49 AM »
Looking for some help out there.  I recently drilled a Blue/Green Centaur with the pin above my bridge and cg kicked about 1/2 to the left of the midline, I am left handed.  PAP is 5 1/4 over, 7/8 up.  My problem with this ball is the same problem I have with other low diff. cores and urethane, the ball rolls over the thumb.  Another ball I had the same problem with ws a V2 Dry.  Are there any suggestons out there as far as pin placement or anything else?  Ironically, the one urethane ball I didn't have this problem iwth was the glowing amulet.
Logged

 

ShoreLefty

  • Full Member
  • ***
  • Posts: 181
Re: Low Diff balls an somewhat high track
« Reply #1 on: December 08, 2006, 02:16:09 PM »
ttt
Logged

Hellbound

  • Full Member
  • ***
  • Posts: 223
Re: Low Diff balls an somewhat high track
« Reply #2 on: December 09, 2006, 09:42:09 PM »
Had the same problem with similar drillings on lower flaring balls...
I now put the pin above,and about 1/2" to the right of ring finger...cg kicked out 1/2 to 3/4"...no more thumping!
good luck....
--------------------
Ambition is a poor excuse for not having enough sense to be lazy.......
Logged
Ambition is a poor excuse for not having enough sense to be lazy.......

Hellbound

  • Full Member
  • ***
  • Posts: 223
Re: Low Diff balls an somewhat high track
« Reply #3 on: December 09, 2006, 09:42:55 PM »
i should have added im a righty....
--------------------
Ambition is a poor excuse for not having enough sense to be lazy.......
Logged
Ambition is a poor excuse for not having enough sense to be lazy.......

ShoreLefty

  • Full Member
  • ***
  • Posts: 181
Re: Low Diff balls an somewhat high track
« Reply #4 on: December 11, 2006, 06:35:41 AM »
Thanks a lot for the input.  I will have to try kicking the cg out.  I will even try it on a new centaur, by far the best fry lane ball imo.
Logged

TWOHAND834

  • Hero Member
  • *****
  • Posts: 4350
Re: Low Diff balls an somewhat high track
« Reply #5 on: December 17, 2006, 12:53:39 PM »
The best way to combat this, is to take the pin and swing it out closer to the PAP.  This will get the ball flaring earlier which gets the flare off the thumb faster.  Put the pin around 4 inches from the PAP and set the CG about 4 - 4 1/2 from the PAP.  Only swinging the CG out just makes the backend reaction rollier than flippy.  The pin is the key.
--------------------
Steven Vance
Former Pro Shop Operator

If anyone out there is worried about the scores being too high, try duckpin!!
Logged
Steven Vance
Former Pro Shop Operator
Former Classic Products Assistant Manager
Pages: [1]
« previous next »